Boost Your Productivity!Translate documents (Ms-Word, Ms-Excel, ...) faster and better thanks to artificial intelligence!
https://pro.wordscope.com
https://blog. wordscope .com
Horizontal plane of the discovery point
Horizontal plane through a point
Side-lobe characteristic in the horizontal plane

Übersetzung für "Horizontal plane the discovery point " (Englisch → Französisch) :

TERMINOLOGIE


horizontal plane of the discovery point

étage au niveau du point de découverte


parallelism in the sawing direction of the travelling table to the table of the machine in the horizontal plane

parallélisme dans le sens de sciage de la surface du chariot à celle de la table de la machine, dans le plan horizontal


parallelism of the auxiliary travelling table with respect to the fixed table in the horizontal plane

parallélisme dans le plan horizontal des surfaces du chariot à tenonner et de la table de la machine


parallelism in the transverse direction of the travelling table of the machine, in a horizontal plane

parallélisme dans le sens transversal de la surface du chariot d'équarrissage à celui de la table de la machine dans le plan horizontal


side-lobe characteristic in the horizontal plane

caractéristique des lobes latéraux dans le plan horizontal
IN-CONTEXT TRANSLATIONS
Mark a point "A" on the backrest on the same horizontal level as the shoulder of the smallest manikin at a point 2 cm inside the outer edge of the arm. All internal surfaces above the horizontal plane passing through point A, shall be tested in accordance with Annex 17.

Faire une marque sur le dossier au point “A”, situé à la hauteur de l’épaule du plus petit mannequin en un point se trouvant à 2 cm vers l’intérieur du bord extérieur du bras. Toutes les faces intérieures au-dessus du plan horizontal passant par le point A doivent être soumises aux essais prescrits à l’annexe 17.


In this case, the permitted area as defined above may be enlarged by shifting it 80 mm upwards and downwards in the vertical direction; however, the permitted area remains bounded by the horizontal plane passing through point C (See Figure 11-P2-1).

Dans ce cas, la zone autorisée telle que définie ci-dessus peut être élargie en la déplaçant de 80 mm vers le haut et le bas dans la direction verticale; toutefois, la zone autorisée reste confinée par le plan horizontal passant par le point C (voir figure 11-P2-1).


(a) an imaginary inclined plane extending upward and outward from the intersection of imaginary vertical planes passing through the heliport boundary, with imaginary horizontal planes lying 2 m above the general ground level of the heliport boundary at any point thereon, to a maximum elevation of 792 m above sea level at the outer limit of the approach surface, being 115 m, more or less, above the assigned elevation of the heliport ...[+++]

a) un plan incliné imaginaire qui s’élève vers l’extérieur à partir de l’intersection de plans verticaux qui coupent les limites de l’héliport, avec les plans horizontaux imaginaires qui se trouvent en tout point à 2 m au-dessus des limites des terrains de l’héliport, jusqu’à une élévation maximale de 792 m au-dessus du niveau de la mer, à la limite extrême de la surface d’approche, à environ 115 m au-dessus de l’altitude assignée au point de repère du ...[+++]


(ii) in the horizontal plane of its image plane to no greater than the maximum allowable limit of neck rotation specified in SAE Recommended Practice J1050, at a point corresponding to the neck pivot point as specified in that Recommended Practice, only after the maximum limits of eye rotation have been reached;

(ii) sur la plan horizontal, son plan image ne dépasse pas la limite maximale permise de rotation du cou précisée dans la pratique recommandée J1050 de la SAE, au point correspondant au point de pivotement du cou tel qu’il est précisé dans cette pratique recommandée, et ce, seulement après que les limites maximales de rotation de l’oeil ont été atteintes;


For more results, go to https://pro.wordscope.com to translate your documents with Wordscope Pro!
(2) A forward-facing child restraint system is not required to conform to the requirements of paragraphs 215(1)(e) and (f) if the target point located on either side of the head of the heaviest of the anthropomorphic test devices used in the dynamic test — other than an anthropomorphic test device specified in subpart I, N or S, part 572, chapter V, title 49 of the Code of Federal Regulations of the United States (revised as of October 1, 2012) — and located on the transverse axis passing through the centre of mass of the device’s head and perpendicular to the head’s midsagittal plane ...[+++]s below a horizontal plane tangent to the top of the standard seat assembly when the anthropomorphic test device is positioned in the restraint system in accordance with subsection 4.4.2 or 4.5.2 of Test Method 213 and the restraint system is installed on the standard seat assembly in accordance with subsection 4.4.1 or 4.5.1 of Test Method 213.

(2) L’ensemble de retenue pour enfant orienté vers l’avant n’a pas à être conforme aux exigences des alinéas 215(1)e) et f) si le point repère situé de part et d’autre de la tête du plus lourd des dispositifs anthropomorphes d’essai utilisé lors d’un essai dynamique visé au paragraphe (1) — autre qu’un dispositif anthropomorphe d’essai précisé à la sous-partie I, N ou S, partie 572, chapitre V, titre 49 du Code of Federal Regulations des États-Unis, dans sa version au 1 octobre 2012 — et situé dans l’axe transversal passant à travers le centre de masse de la tête du dispositif et perpendiculaire au ...[+++]


(4) Install the first spray container in the holding device and ensure that the burner orifice is 15 cm from the discharge orifice of the spray container in the horizontal plane and 5 cm below it in the vertical plane and that the discharge orifice points in the direction of the burner.

(4) Placer le premier contenant pulvérisateur dans le dispositif de fixation et veiller à ce que l’orifice du brûleur soit à une distance horizontale de 15 cm de l’orifice du contenant pulvérisateur et à une distance de 5 cm au-dessous de l’axe vertical de cet orifice et à ce que celui-ci soit orienté vers le brûleur.


(4) Install the first aerosol container in the device and ensure that the burner orifice is 15 cm from the discharge orifice in the horizontal plane and 5 cm below it in the vertical plane and that the discharge orifice points in the direction of the burner.

(4) Placer le premier contenant aérosol dans le dispositif de fixation et s’assurer que l’orifice du brûleur est à une distance horizontale de 15 cm de l’orifice du contenant et à une distance de 5 cm au-dessous de l’axe vertical de l’orifice du contenant et que l’orifice est orienté vers le brûleur.


All internal surfaces above the horizontal plane passing through point A shall comprise special energy-absorbing material tested in accordance with Annex 17.

Toutes les faces intérieures au-dessus du plan horizontal passant par le point «A» doivent être revêtues d’un matériau de rembourrage spécial ayant été soumis aux essais prescrits à l’annexe 17.


These side wings shall start at the horizontal plane passing through point ‘A’ and continue to the top of the seat back.

Ces panneaux latéraux doivent partir du plan horizontal passant par le point «A» et continuer jusqu’en haut du dossier du dispositif.


2.2.20. s0: loss of travel, that is to say the travel, measured in millimetres, of the coupling head when it is actuated in such a way as to travel from a point 300 mm above the horizontal plane to a point 300 mm below, the transmission remaining stationary

2.2.20. s0: perte de course, c'est-à-dire course mesurée en millimètres que parcourt la tête d'attelage lorsqu'elle est actionnée de façon à passer de 300 mm au-dessus à 300 mm au-dessous de l'horizontale, la transmission étant maintenue immobile




datacenter (1): www.wordscope.de (v4.0.br)

'Horizontal plane the discovery point' ->

Date index: 2021-09-07
w