Übersetzung für "Diagnostic position " (Englisch → Französisch) :

principal position | principal position of gaze | diagnostic position | diagnostic position of gaze | cardinal position

use automative diagnostic tools | utilise automotive diagnostic tools | apply automative diagnostic equipment | use automotive diagnostic equipment

perform electrical repairs using diagnostic equipment | use diagnostic equipment for repairing electronics | analyse problems using diagnostic equipment during electrical repairs | use diagnostic tools for electronic repairs

make use of diagnostic imaging procedures | use diagnostic imaging procedures | carry out diagnostic imaging procedures | perform diagnostic imaging procedures

Classical Swine Fever Diagnostic Manual | Diagnostic Manual establishing diagnostic procedures, sampling methods and criteria for evaluation of the laboratory tests for the confirmation of classical swine fever

diagnostics by microwave method | microwave diagnostic technique | microwave diagnostics

on-board diagnostic system | on-board diagnostics | OBD [Abbr.]

diagnostic tool | diagnostic software | diagnostic program | diagnostic routine | diagnose program

diagnostic centre [ diagnostic facility | diagnostic institution | diagnostic center ]

on board diagnostic | OBD | on-board diagnostic | on-board diagnostic system | self test

(7) In order to achieve Union air quality objectives and to ensure a continuous effort to reduce vehicle emissions, the power to adopt acts in accordance with Article 290 of the Treaty on the Functioning of the European Union (TFUE) should be delegated to the Commission in respect of the detailed rules on the application of Regulation (EC) No 715/2007 to vehicles of categories M1, M2, N1 and N2 with a reference mass exceeding 2 610 kg but with a maximum vehicle mass not exceeding 7 500 kg, the specific procedures, tests and requirements for type approval, the requirements for the implementation of the prohibition on the use of defeat devices that reduce the effectiveness of emission control systems, the measures necessary for the implementa ...[+++]tion of the obligation of a manufacturer to provide unrestricted and standardised access to vehicle repair and maintenance information, including remote diagnostic support, the review of the information on the mass of CO2 emissions in the certificate of conformity with information on total mass of CO2 emissions equivalents, the increase of the limit value of total hydrocarbons emissions for positive ignition vehicles, the amendment of Regulation (EC) No 715/2007 for the purposes of recalibrating the particulate mass based limit values and introducing particle number based limit values that would correlate broadly with the petrol and diesel mass limit values, the adoption of a revised measurement procedure for particulates, including nano-particulates, and a particle number limit value, a limit value for emissions of NO2 and limits for tailpipe emissions at cold temperatures for vehicles approved as complying with the Euro 6 emission limits.

If available, the following signals in addition to the required freeze-frame information shall be made available on demand through the serial port on the standardised diagnostic connector, if the information is available to the on-board computer or can be determined using information available to the on-board computer: diagnostic trouble codes, engine coolant temperature, fuel control system status (closed-loop, open-loop, other), fuel trim, ignition timing advance, intake air temperature, manifold air pressure, air flow rate, engine speed, throttle position sensor ou ...[+++]tput value, secondary air status (upstream, downstream or atmosphere), calculated load value, vehicle speed, the position of the antilock brake system switch (on/off), the activated default mode(s) and fuel pressure.

3. Where a national authority responsible for notified bodies is responsible for designation of notified bodies in the field of products other than in vitro diagnostic medical devices, the competent authority for in vitro diagnostic medical devices shall provide, prior to the notification, a positive opinion on the notification and its scope.

(b) the clinical performance, such as diagnostic sensitivity, diagnostic specificity, positive and negative predictive value, likelihood ratio, expected values in normal or affected populations.